|07-30-2011, 05:35 AM||#1|
Sure, I can do that!
Joined: Jun 2011
Location: 200 miles north of New Orleans
Classic wheels for my power chair -or- "Drivin' Mr. Crazy!"
Here is where we are at the moment ...
I have completed some intake and exhaust modifications to increase power just a bit.
The fine folks at Woody's Wheel Works have re-spoked my rear and side wheels, and I will also have the front wheel done later on while adding the Steerite modification to the forks as a "finishing touch" after the matters of toe-in and lean have been addressed.
I have found a 1500# 12-volt actuator for adding "electric lean" to the entire rig rather than just leaning the tug -- I learned about that from one of Woody's posts somewhere -- and I will build a little toe-in into my frames and then do some final tweaking at the sidecar wheel (with beveled spacers and washers or whatever to keep from bending the axle).
I have my new tires installed, and my custom plate from the State should be here soon: YMAHAK ...
He who so shall, so shall he who.
leejosepho screwed with this post 09-13-2011 at 06:34 AM Reason: update
|Thread Tools||Search this Thread|