|09-07-2011, 09:28 AM||#16|
Joined: Jun 2009
Location: the hills
Plugs foul because they cannot reach proper operating temperature that keeps the insulator clean. You need to find out why that is happening and fix it. I think you've covered it with the oil consumption and oil on the plug causing the fouling. A leak down test would help isolate the cause.
P.S. Always run a resistor plug even if not required per Smokey Yunick February 1991.
you don't see luggage racks on a hearse..........act accordingly
|09-07-2011, 03:35 PM||#17|
Joined: Apr 2008
Location: dammit..back in the states
somewhere Snobum said it was a mandatory no-no to use resistor plugs in pre 85 airheads...I think that was the
story anyway....what does anyone know about this. I'd like to put Iridium's in my 83,
I had a 2001 650 GS that surged like hell, a single plug version - I switched to an Iridium plug, and it solved about
90% of the surging...just the plug change was done.
James (sometimes known as Janes on certain posts in "rockies" section)
|09-07-2011, 06:16 PM||#18|
Old Enough To Know Better
Joined: Feb 2005
Location: Merritt Island, FL
Where RFI is a potential concern, as in CDI ignitions, I've always been taught that either resistor wires, resistor caps, or resistor plugs were sufficient but only one was needed and the others became detrimental if added into the circuit. On the airhead I run resistor wires since they are closest to the CDI. On the F 650 I have stock wires and NGK resistor caps (it came stock with Behru resistor caps), and non-resistor plugs because the CDI is at the back of the bike away from the secondary ignition circuit.
Still, I'd like to hear Smokey Yunick's opinion - he was the man! And his knowledge is still very much applicable today.
Merritt Island, FL
When a person asks you for advice, they don't want advice. They want corroboration.
|09-09-2011, 10:25 AM||#19|
Joined: Nov 2007
Location: Lewisville, NC
Thanks for all the input and suggestions !!
I think I got it solved, as per usual it was the simplest of things.
Decided to do a maintenance on the bike, Oil & filter, valve lash and a carburetor balance.
The oil that came out was nice and dark, no bits or pieces floating around. Stuck a swab up in to the pan and took a look for swarf. Clean as a whistle!!
Filter was also clean , had the proper white rubber O ring and a spacer. Replaced all that.
Valves were all in spec !!
On the carburetors I discovered a fault !!
When i removed what i thought were vacuum caps, were actually just pieces of vacuum line !!
Some rocket scientist trying to save a nickle had put a small ball bearing inside the opening to stop any air leaks, unfortunately one of the balls was missing.
Ergo; rough idle, poor mixture = plug fouling
Replaced that fubar and went for a ride.
Amazing how much better and stronger the bike runs.
|Thread Tools||Search this Thread|