|01-28-2012, 05:31 AM||#1|
Joined: Dec 2010
Location: Athens, GA
spline lube and transmission questions
after a successful fork rebuild a couple weeks ago, i thought i'd try my hand at the famous "spline lube" while i have some garage access this winter. i've been reading up on a ton of posts and forums about the process of just pulling the transmission back an inch or so and doing it that way, but i've been thinking about going "all in" and taking it completely off and poking around a bit.
as i've mentioned in previous posts, i have zero history on the bike so i've been trying to get all the main parts checked out when i have the opportunity and i assume this will be the perfect time to check on other things while i have it all apart.
i haven't been able to find any posts where anybody does this specifically and was wondering if anyone could give me a general list of the "easy" things to check while i'm in there. i've got the clymers and haynes books which i assume will give me the process in getting the trans apart, but i'm not really sure what i'd be looking for and what would look bad or not.
things i can guess i should check (from what i've heard) would be the flywheel, rear main seal, neutral switch. lube the splines as my intention in the first place. anything else? what would i be looking for in those areas listed?
also, is there anything i should be careful with or avoid?
thanks in advance!
|Thread Tools||Search this Thread|