ADVrider

Go Back   ADVrider > Bikes > GSpot > Parallel Universe
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 06-01-2012, 03:32 PM   #1
murdock84 OP
Studly Adventurer
 
Joined: Apr 2012
Location: Elizabethtown, PA
Oddometer: 544
Rear Brake Lever Install Help

I ordered a Tourtech rear brake lever with the folding tip. I got the stock lever off and found that the Tourtech one needed the rear hole where the pin goes drilled out a little to get the pin back in. Anyway when I went to put the pin back and then install the brake lever the part that the pin attaches to came out of the little rubber boot. It doesn't appear to want to go back into the rubber boot and stay in place now. It looks like there is grease in there. How do I get this back in there properly?

Hell installing the GPS mount and wiring it up was easier then taking a bolt off the brake pedal and trying to get it back together.

Thanks!
murdock84 is offline   Reply With Quote
 

Share

Thread Tools Search this Thread
Search this Thread:

.
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


Times are GMT -7.   It's 06:49 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014