ADVrider

Go Back   ADVrider > Bikes > GSpot > Parallel Universe
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Search this Thread Display Modes
Old 12-02-2010, 09:29 AM   #16
Bucko
In a parallel world
 
Bucko's Avatar
 
Joined: Mar 2004
Location: South Coast, CA
Oddometer: 807
Bluhduh Long reach

My only complaint about BB's and Kaoko is that it's a long reach out to the the Kaoko to operate the knob. Nobody's fault, since that's the distance they had to deal with, but I do have some trouble getting my wimpy little finger across the gap between the handgrip and Kaoko to twist that sucker. Knowing what I do now, I'd probably go with the OEM handguards if I was going to fit a Kaoko.
Bucko is offline   Reply With Quote
Old 12-02-2010, 08:26 PM   #17
inmate-n00b
Ciao, Marco
 
inmate-n00b's Avatar
 
Joined: Oct 2009
Oddometer: 1,006
Here is part of the instructions that came with the kaoko that's made specifically for barkbusters. It's KAO.KBB700-S for the kaoko and BHG32 for the barkbusters.
You can see in Picture 3 that the "thrust washer" is on the left, then the knobby part of the kaoko, the friction nut, and finally the barkbuster.

Initially, I thought the thrust washer goes under the throttle grip. That's the way my throttlemeister worked on my sportbike. Now, I think it's the 5mm washer shown, which is used on the R1200GS. This was the source of my confusion.

The kaoko bar end is pretty lightweight. I may revisit the duct tape and wheel weight idea, like when there's two feet of snow on the ground and I run out of stuff to do.


inmate-n00b is offline   Reply With Quote
Old 07-15-2011, 10:40 AM   #18
Icy Roads
Adventurer
 
Icy Roads's Avatar
 
Joined: Apr 2008
Location: Alberta
Oddometer: 57
Just curious

Quote:
Originally Posted by WoodWorks View Post
I dunno about installing them with Barkbusters, but it looks like you've installed it backwards. Isn't the knurled part supposed to go up against the grip, like this?



David
I'm curious did it work with nut on the far side of the spacer?
__________________
Icyroads
Icy Roads is offline   Reply With Quote
Old 07-31-2012, 12:38 AM   #19
ngng
Adventurer
 
ngng's Avatar
 
Joined: Jun 2012
Location: Cupertino, CA
Oddometer: 65
In the instructions it says you can adjust the throttle play with the 2mm grub screw. Does anybody have a photo of this? The included instructions had some low resolution photos. Right now, I have to crank the Kaoko all the way off so the throttle doesn't stick, not a huge deal, but I wouldn't mind adjusting the play.
ngng is offline   Reply With Quote
Reply

Share

Thread Tools Search this Thread
Search this Thread:

.
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


Times are GMT -7.   It's 05:12 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014