ADVrider

Go Back   ADVrider > Bikes > GSpot > Parallel Universe
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 09-03-2012, 02:12 PM   #16
JRWooden
Beastly Adventurer
 
Joined: Jul 2008
Location: The great state of confusion
Oddometer: 4,112
On the one page of troubleshooting notes I keep on my bike at all times I have it written (so it must be true)

That "Joel said":
There are only two sensors that were absolutely required for the bike to run (notice I didn't say "run well" I just said "run")
They would be the TPS and the crankshaft position sensor. If the BMS-K gets an "open circuit" reading to any other sensor it goes into "limp home" mode and just does the best it can do without input from that sensor. Unfortunately sometimes the sensors fail in a "believable state" such that the BMS-K thinks that the signal is valid which causes confusion.

I would "hot-wire" around the pump controller and unplug the pressure sensor
(not both at the same time ... try one then the other then both ... see what changes)
JRWooden is offline   Reply With Quote
 

Share

Thread Tools Search this Thread
Search this Thread:

.
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


Times are GMT -7.   It's 07:36 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014