Go Back   ADVrider > Bikes > Orange Crush > Crazy-Awesome almost Dakar racers (950/990cc)
User Name
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 11-18-2012, 02:18 AM   #1
rider911 OP
Gnarly Adventurer
rider911's Avatar
Joined: Sep 2009
Location: Australia
Oddometer: 477
FYI - Oil Pressure Sender Unit

I have just come across a problem that some of you maybe interested in.

I read an RR awhile ago where a 990 sprung a bad oil leak which turned out to be the oil pressure sender unit. This is not really an uncommon occurrence in the automotive world. The guy was in a remote area and it took a week to get the part sorted.
So being someone who frequents remote areas I thought I should replace mine with a new one, and because they were so cheap (<$10) I bought another as a spare. I have been carrying the spare for awhile waiting until I got around to doing the valve check. Alot of stuff has to be taken off to access the sender so you really dont want to do it on the side of the road if possible.

I went to replace it today as I have the bike stripped down and I noticed the new copper washer would not go down flush to the mating surface of the sender. The corner where the thread meets the sealing surface was very untidy and oversize, I checked the spare and it was the same. The color of the unit is different to the original but it has the same ID stampings. So I stuck it in the lathe and carefully machined the thread diameter all the way to mating surface. Easy... job done... or so I thought.

I then noticed that the end of the thread finished well short of the mating surface and it struck me that I may need a thicker copper washer. I screwed the unit in without the washer and measured with feeler guages the clearance after the sender lightly bottomed out on the thread. The clearance was exactly 0,8 mm. I obviously then measured the new washer... 0.8 mm So of course I'm going to need a thicker washer.

The problem is I'm an inquisitive bastard and I wanted to know how this could be. I checked the part numbers to make sure I had the correct parts, all good. I then measured the old copper washer which was 0.78, so that was the same. I then screwed the old sender unit in and measured the clearance without the washer and strangely enough it also bottomed out at 0.8 mm ..... WTF. how had this been sealing so well for 60000km.
After much head scratching I looked at the copper sealing ring decription on the packet and it claimed to be 1.0 mm thick which if true would solve the problem.
I found a new copper washer in my collection which was 1.2 mm thick and I was good to go.

So the point of this long winded post is that if anyone like me has been carrying a new spare sender around with them, its probably not going to fit without some preparation.

New RR ~ Across OZ... Corner by Corner

08 KTM 300 exce (small)
12 KTM 500 exc (medium)
07 KTM 990 Adv (large)
rider911 is offline   Reply With Quote


Thread Tools Search this Thread
Search this Thread:

Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump

Times are GMT -7.   It's 09:30 AM.

Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2015