ADVrider

Go Back   ADVrider > Bikes > Old's Cool > Airheads
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 12-07-2012, 12:50 PM   #1
mrbindc OP
Adventurer
 
Joined: Apr 2012
Location: Alexandria, VA
Oddometer: 75
Installing Mikuni carbs

I took the leap and ordered up the Mikuni carb kit from Rocky Point Cycle. The old Bings were in need of a rebuild, which I am planning to do, but I thought I'd try out the RPC kit for a comparison. The difference in the colour of the floats in the Bings was interesting.




The Mikuni carbs are very slick, I like how the RCP kit uses two different models so you can set them up with the idle screws on the outside. RCP recommends soaking the rubber connectors in hot water to make the installation easier. After a soak they went on without any drama.

I think I may just JB weld them to the rubber connectors instead of using the clamps...



mrbindc is offline   Reply With Quote
 

Share

Thread Tools Search this Thread
Search this Thread:

.
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


Times are GMT -7.   It's 08:02 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014