ADVrider

Go Back   ADVrider > Bikes > Old's Cool > Airheads
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 12-22-2012, 07:18 PM   #11
digger440 OP
Adventurer
 
digger440's Avatar
 
Joined: Nov 2012
Location: Very northwest corner of the USA
Oddometer: 74
So I finally got some time to work on that outboard pipe that I did not like and do a little more of the exhaust system.


I cut the outboard pipe in order to add in a section of bend to bring it up higher



At least I got to see how my welding was looking on the inside





I added in the small section which put the pipe up quite a bit higher but it now does not match up X pipe I made




So I have to cut it again and add in yet another bend



Now that the piper was higher I had to modify the corresponding pipe on the X-pipe I ended up adding a small bend to it and using some heat to fine tune it


and now the finished product










Since I am finally done I can start to route the pipes up under the seat to finish this portion off










I only had 2 hours tonight to get this done so I was not able to finish the exhaust off completely however the next photo give an Idea of where it will exit and what it will look like when I am finished







I will spam this board with more photos as I take them
__________________
R100 cafefighter build in progress
http://www.customfighters.com/forums...ad.php?t=85610
digger440 is offline   Reply With Quote
 

Share

Thread Tools Search this Thread
Search this Thread:

.
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


Times are GMT -7.   It's 07:09 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014