Go Back   ADVrider > Bikes > Orange Crush > Crazy-Awesome almost Dakar racers (950/990cc)
User Name
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 12-23-2012, 07:44 PM   #1
666 OP
Agnostic and Orange
666's Avatar
Joined: Feb 2005
Location: San Francisco, CA
Oddometer: 1,320
water pump cover tube o rings?

I was replacing water pump seal today. First time on this bike - 31k miles. 2006.
Original stock, didnt go bad yet, but I had time.
When I was pulling the aluminum "tube" from the cover o-rings were not "together"(like in Pyndon's rebuild report on HOW), but on either side of the tube "bulge". It never leaked(visibly) from there and came that way from the factory.
Did anybody else had orings from factory installed the same way?
It may explain why I always had to add a little bit of coolant .

Here 2 pictures from Pyndons rebuild, clearly both o rings on the inside, so I installed it the same way.

Shaft looked just fine, no wear. But some milky stuff was between shaft bearings and seal - may be it was about to go.
Here is shaft:

here is milky stuff
2006 KTM 950 ADV; 2006 KTM 525EXC; 2013 Tiger 800 street
Moab Ride Report
Dusy Ershim Ride Report

666 screwed with this post 12-24-2012 at 10:48 AM
666 is offline   Reply With Quote


Thread Tools Search this Thread
Search this Thread:

Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump

Times are GMT -7.   It's 08:22 AM.

Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2015