|01-04-2013, 08:07 PM||#6541|
Joined: Dec 2005
Location: Iron Co. Utah
06' KTM 640ADV w/ SMC conversion
06 640 ADV w/SMC conversion
In for some general maintenance tonight. $3000 O.B.O. 29,678 miles. Me and the Mrs.'s are moving and I could use the money. Runs strong. A quick top end refresh and you'd be GTG for another 30k miles. Doesn't burn oil. It's been a "grocery getter" for the past year and I'm moving on. If you're not into working on your bike yourself I'd consider something else. Guns&ammo trades considered(556,308,45ACP). I'll upload some current dressed pics when I'm finished with the maintenance. Bike is in Seattle, Wa. Thanks for looking!
Currently a sporting a 908r & 606fr w/ some tread left, 6k mi. on sprockets(42-15t) and chain. Oil change and valve check done as of Jan 13'. All maintenance and mod's have been done by myself since 6k mi. The SMC conversion was done at 11k mi. This bike is set up for a 6' 1" tall 180-210lb rider. Still does 80MPH @ 6300RPMs and will do 95 without effort. Top speed so far 110MPH GPS indicated. Fuel range 220-240mi dry. Here's the list as best as I can recall:
oil changes & valve checks every 1-3k mi(condition dependent, using Motorex 10/50w)
countershaft oring & seal replaced @ 6k & 20kmi
new H2O pump @ 20k
rallye cam installed @ 20k
Akra Ti exhaust w/ Leo Vince cans (spark arrested)
secondary switchable radiator fan
large LC4 airbox w/ hardparts cover
new clutch slave cylinder, fuel pump, battery @ 6k( warranty)
switchable ignition (run with headlights on or off)(from factory)
SPS suspension upgrade @18k (revalve/ respring 180-210lb rider)
Woody's wheels @18k superlaced S.S. spokes/ nipples, RAD hubs, Excel
RTT billet steering damper/ upper triple clamp 2 3/4" rise
EXC front master cylinder
Fastway footpegs (low position)
fr & r wave rotors
new rear brake switch @ 15k
new brake pads fr & r @ 18k
steering head bearing replaced @10k
steering head/ rear linkage serviced @ 18k
kickstand switch disabled
High fender and fork guards
assorted oil change crush washers
valve cover gaskets
clutch slave cylinder/ countershaft oring
stock foot pegs + passenger
assorted FCR main and pilot jets + needles (JD)
stock front brake master cylinder and r side caliper
stock rear rotor
stock cush hub sprocket carrier + rubbers
stock rear spring
left engine sidecase (used)
intake/exhaust cam follower bearings (new)
stock cam shaft
stock SMC airbox cover
SMC rear brake light and turn signal wire loom
SMC rear license plate carrier
Set of Sahara's 75%
|01-04-2013, 09:47 PM||#6542|
Joined: Feb 2005
Location: Kenmore WA
2006 F-150 Wheels W/Tires
Hi, I am selling (2) wheels and tires off of my 2006 Ford F-150. Both wheels are balanced, but do not include tire pressure monitors.
(2) Front Tires/Wheels - Firestone Destination A/T 235/70R 17 108S M+S Includes the wheel center caps & Lug Nuts - Condition is almost new. Still has nubs on both sides of the tires. No damage, excellent shape. $100 for the pair.
I will also include a set of (4) Chrome Hubcaps with the purchase. Send me a PM or email if interested.
|01-05-2013, 09:03 AM||#6543|
Joined: May 2010
Location: Rainy, Wa
free fmf q4 for a 690. It is down in issaquah. I just repacked it but replaced the exhaust with a wings.
2012 300 EC Race
2010 690 R
2007 990 S
|01-05-2013, 09:40 AM||#6544|
Howling "Mad", Adventurer
Joined: Aug 2001
Location: Granite Falls, Washington State, USA
Dave, aka "Mr. Cob"
My photos, http://mr-cob.smugmug.com/ Help a CHEAP bastard keep his Smugmug, use this coupon ( geyYbNZwLLrl6 ) thank you.
|01-06-2013, 09:54 AM||#6546|
Joined: Jan 2008
Location: Green. Wet. Oregon.
Looking for bar risers
Seems a previous deal fell through (or maybe he fell off the planet, I'm not sure), so I'm looking for some bar risers in the Portland or Corvallis area to put on my Transalp.
Always chase your dreams. Even if you don't catch them, you'll have a hell of a time trying.
Current: 1989 Honda Transalp, 2006 Scorpa TY125F trials
Past: 1999 KLR 650, 1990 Tengai 650
|01-06-2013, 11:38 AM||#6547|
Master of the Obvious
Joined: Aug 2007
Location: North Central Washington
Can you measure the OD of the inlet for me? I'll take it if I can modify it to fit my Dakar. Seconds after MR. Cob.
Read The Patriot Post -- It's Right. It's Free.
Sometimes the light to see your way forward is provided by the bridge burning behind you.
|01-06-2013, 04:01 PM||#6548|
Joined: Jun 2008
Location: Sunnyside Wa
Vstrom Dl650 saddle bags
I am selling my stock saddle bags from my 2011 DL650.
I have decided to go with pelican boxes instead.
They have spent most of the last year sitting on a shelf in my basement.
This is for the bags only as I am going to use the stock mounts for the pelican cases.
I am asking $200. If your interested I can email you pictures.
I would prefer not to deal with shipping them if possible. I would be willing to meet someone at a reasonable halfway distance.
PM me if you are interested.
|01-06-2013, 04:45 PM||#6549|
Logging Road Cruiser
Joined: Oct 2009
Location: Gig Harbor, WA
1972 Suzuki RV90
Edit 05/2013: It's for sale again :)
Speed with my 225lb body on it 50mph downhill, 45mph on flat ground and 20ish up a hill.
RV 90 J Rover 1972
Dry Weight: 84 kg (185 lbs)
Engine type: 88 cc air-cooled aluminum single cylinder 2-stroke, reed valve. 8 hp/ 6,000 rpm, 7.23 ft-lb/ 4,000 rpm.
Clear Washington Title In My Name (Street plated)
Starts easy, usually smokes for 1-2 miles then clears up. (bike has an auto oiler) so if you let it sit for a month or two a little oil finds it's way past the oiler into the engine and makes smoke when first started.
**Bypassing the auto oiler on the rv90 engines is a death sentence**
Newer tires and tubes (under 40 miles)
Very low miles on chain and sprockets
New clutch discs (under 50 miles)
New handlebar brush guards
New seat & seat cover
Wheel bearings replaced (two years ago)
6v battery tender jr
Comes with a decent box of spare parts and two different shop manuals.
It could use a new set of front brake pads
A lot of it's parts are still available from Suzuki dealers.
Blinkers are taped because I've lost lens covers during long trail rides.
Every gear has a pretty narrow power band.
Yup I put in a capacitor under the seat to help smooth out the voltage when using the blinkers.
I rescued it from a nasty storage unit in Alaska January 2009. (see my pics in rv90 thread)
I put about 30 miles on it a year when I go camping/hunting.
It's old enough to get collector plates
I'm looking to get $700 for it but I'm also open to trades.
Examples.....14-16' camp trailer, small boat (14-16') or honda mini trail (not interested in electronics or firearms)
PM me your ideas
My Normal Riding Areas
N46 40.609 / W122 15.074
N46 41.052 / W122 16.787
N46 39.164 / W121 35.020
N47 19' 24.73" / W123 16' 23.73"
rm_hm screwed with this post 05-06-2013 at 04:11 PM
|01-06-2013, 07:25 PM||#6550|
Joined: Sep 2005
Location: Sunny PDX
Old-school snow shovel. Rare metal blade that doubles as snow anchor and fits the shaft of your ice axe. Great for the fast and light enthusiasts or add to your collection of antique gear.
$40 plus shipping.
Another antique: a pair of crampons. $20 plus shipping and I'll throw in the sweet fanny pack.
Hella 1402 lights. Used briefly but I didn't like how they looked mounted on an F650 I had a few years ago. $20 plus shipping.
soyanarchisto screwed with this post 01-08-2013 at 08:47 AM
|01-07-2013, 05:40 PM||#6551|
Joined: Jul 2002
Location: Bend Oregon
KLR bits Free
I have two sets of fork preload spacers. 1 set is 2 inches long. the other 5 1/2 long both steel
Also have a OEM front fender, olive green with scratches
From a pre '08
Keep it Wild, Keep it Free
Parting '98 1100GS. Need Anything?
|01-08-2013, 03:30 PM||#6552|
Joined: May 2009
Location: The Evergreen State
F/S: Epiphone SG400 Guitar Kit
Selling my Epiphone SG400.
This is a great guitar in excellent condition, hardly ever played or even taken out of the case. It does include a hard case that is in good condition.
Retails for about $400, but I would like to get $210 obo (adv discount versus my ad on CL for $220), as it is like new with a hard case included.
Also for sale:
Peavey Rage 158 Amplifier--$50
Crybaby Wah-Wah Pedal, like new, never used--$50
***Buy all three together and I will sell them for $260 obo.
Email or PM for delivery/pickup options.
|01-08-2013, 03:31 PM||#6553|
Joined: Oct 2008
Location: Zillah WA, The Dalles OR
Ruckus for a DS project?
I have a great running 2008 Honda Ruckus with 1,200 miles on it. I'm interested in trading it for a Dual Sport project bike, running or not. Actually, I'm open to any bike but a DS is preferred. This Ruckus has a salvage title as it was a theft recovery. I replaced the damaged ignition with new Honda bits. This scooter has no damage and runs perfect. I believe it's worth $1,400 ish, I would sell it outright too. It's located in Zillah WA. Ron, 509 969 6999
2010 BMW R1200GS, 2010 Ducati Monster 1100S, 2011 WR250R, 1985 Beta TR32
|01-08-2013, 03:49 PM||#6554|
Joined: May 2009
Location: The Evergreen State
F/S: Biker Leathers
I have up for sale 2 leather jackets.
1) Brooks leather biker jacket, excellent condition, size 44. Not too sure how old it is, but I have had it for at least 15 years. Hardly ever wore it, mainly kept it for costumes. Made in USA, good quality jacket. Does have some Harley propaganda pierced or sewed into it...Asking $200 obo.
photobucket is half tard and not rotating when I copied the links...
2) Harley Davidson distressed leather jacket, like new (or like vintage depending on how you look at it), size Large. $75 obo.
***Bonus, first person to buy a jacket gets a free pair of leather biker chaps. The assless kind. Awesome. Or, buy them separate for $25.
PM or email for delivery/pickup information.
|01-08-2013, 09:36 PM||#6555|
Joined: Feb 2005
Just a friendly reminder....
This thread is for regional flea market posts ONLY. Keeping the banter to a minimum will help the bikes/gear/stuff offered be more visible. Please go back to your original post and edit it once the item is gone.
National Suicide Prevention Lifeline 1-800-273-TALK (8255)
|Thread Tools||Search this Thread|