"Clocking" airhead drive shaft?

woodly1069 · 01-26-2013, 09:05 AM

Just wondering if I need to reassemble the drive shaft from my R75/5 in any relative position? See when we had it in the press and were heating it up, it went BOOM! Knocked my buddy on to the floor and then I fell down laughing at him

Problem is, I guess my dumb ass must have baked the markings right off the parts...

I see that there is a small hole in the largest part of the OD on the spline connection and since there is just a taper for a press fit it can line up with anything...any thoughts?

01-26-2013, 09:05 AM	#1
woodly1069 ^OP Beastly Adventurer Joined: Jun 2008 Location: Louisville, KY...really too far from the hills! Oddometer: 1,091	"Clocking" airhead drive shaft? Just wondering if I need to reassemble the drive shaft from my R75/5 in any relative position? See when we had it in the press and were heating it up, it went BOOM! Knocked my buddy on to the floor and then I fell down laughing at him Problem is, I guess my dumb ass must have baked the markings right off the parts... I see that there is a small hole in the largest part of the OD on the spline connection and since there is just a taper for a press fit it can line up with anything...any thoughts? __________________ If you can't fix it with a hammer, you've got an electrical problem!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: .
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode