Advice on an RD 250 build

sprouty115 · 02-07-2013, 06:36 PM

Forgot to add this pic. When I was fitting one of the cylinders I discovered a chunk missing from the edge of the lower cooling fin. Looked at the other cylinder and sure enough there was a chunk missing there too. Doesn't effect anything but just more evidence that the previous mechanic clearly only had two tools: a hammer and a bigger hammer.

Cylinders bottom

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: .
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-07-2013, 06:36 PM	#37
sprouty115 ^OP Gnarly Adventurer Joined: May 2012 Location: New England Oddometer: 187	Forgot to add this pic. When I was fitting one of the cylinders I discovered a chunk missing from the edge of the lower cooling fin. Looked at the other cylinder and sure enough there was a chunk missing there too. Doesn't effect anything but just more evidence that the previous mechanic clearly only had two tools: a hammer and a bigger hammer. Cylinders bottom