![]() |
01-22-2013, 05:01 PM
|
#1 |
|
Adventurer
Joined: Dec 2008
Oddometer: 41
|
RPM gauge install on G650X
I have a Trail Tech digital rev gauge to install to my XChallenge. I have a similar setup of a couple of Hondas - just wrap the wire from the gauge around the spark plug lead a few times and tape up. On the BMW however there are two coils each sitting directly on top of each plug without any lead in between
Has anyone installed a rev counter on a G650X before? Can I just wrap the wire around the sparkplug boot? |
|
|
02-12-2013, 08:50 AM
|
#2 |
|
Can I change this?
Joined: Feb 2009
Location: MinneSNOWta
Oddometer: 278
|
I have installed it two ways.
1) just wrap around base of rubber boot (easier on the right hand plug - feed wire from below) 2) expose copper lead and splice into brown power wire in 3 wire harness leading into the coil (either coil) #2 seemed to be the faster response time, so I left it that way.
__________________
There is no such thing as bad weather, only inadequate clothing. |
|
|
![]() |
| Share |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|