Go Back   ADVrider > Bikes > Thumpers
User Name
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Thread Tools Search this Thread Display Modes
Old 03-11-2013, 09:57 AM   #1
Colorado Uli OP
Motociclista Non Elegante
Colorado Uli's Avatar
Joined: Feb 2006
Location: Riding Paradise - Grand Junction
Oddometer: 2,584
KTM 625 Clutch Slave Cylinder Spring?

Damn, I was hosing off my (in pieces and engine out) 625SXC when the water hit the dangling cluch slave cylinder and parts went flying - let's keep the comments on my water jet aiming abilities to a minimum, shall we?
OK, so I found the piston with it's o-ring in good shape (I seem to remember that I replaced that combo some years ago), BUT I can't remember if it takes a spring in that assembly as well. The micro fiche is hard to interpred (pretty small stuff), but if I DO need a spring in there does anyone know what the spring dimensions and aproximate compression rates are? I Really don't feel like buying a whole $105 kit. But maybe I'm hosed (again).

Danke baby.

Colorado Uli screwed with this post 03-11-2013 at 07:37 PM
Colorado Uli is offline   Reply With Quote


Thread Tools Search this Thread
Search this Thread:

Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump

Times are GMT -7.   It's 10:02 AM.

Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2015