ADVrider

Go Back   ADVrider > Bikes > Old's Cool > Airheads
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 11-27-2013, 07:59 PM   #1
R-dubb OP
Dubbious Adventurer
 
R-dubb's Avatar
 
Joined: Aug 2001
Location: San Francisco
Oddometer: 4,795
R90/6 top end overhaul

I'm restoring a bike I owned 35 years ago. I had the heads redone by SJBMW when the motor had about 40k on it. It now has 30k more and has been sitting some. Compression is at 115/120 cold without carbs. That's a little low. There is also some oil getting to the plugs, but no smoking except on hard acceleration. The bores are clean, but pistons seem slightly loose. Heads look just like they did 25 years ago but for some carbon.

I'd like to hone and fit new rings. Does anyone make oversize rings? Or, do I need to buy bigger pistons? Haven't taken measurements yet to see if the bores are straight. Pretty sure they are as nothing is visible that would indicate uneven wear.

Ideas?
R-dubb is offline   Reply With Quote
 

Share

Thread Tools Search this Thread
Search this Thread:

.
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


Times are GMT -7.   It's 12:38 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014