ADVrider

Go Back   ADVrider > Bikes > GSpot > GS Boxers
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 12-28-2006, 06:58 PM   #18
bemiiten OP
League of Adventures
 
bemiiten's Avatar
 
Joined: Jul 2003
Location: Hamilton NJ.
Oddometer: 4,833
The intermediate shaft was placed in the freezer while I heated a 1" set collar on top a kerosene heater. The manual shows pulling the bearing with a puller, but I decided to do the removal with a press instead. I removed the frozen shaft and placed it on top of the heated set collar to warm the bearing for a few minuets. I installed the bearing clamp and put the assembly in the press. The clearance between the gear and bearing is extremely tight. As soon as the bearing moved a little , the clamp was tightened to allow a better bite. The freezing and heating paid off when the bearing came off nicely without excessive force.

bemiiten screwed with this post 12-28-2006 at 07:06 PM
bemiiten is offline   Reply With Quote
 

Share

Thread Tools Search this Thread
Search this Thread:

.
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


Times are GMT -7.   It's 04:00 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014