ADVrider

Go Back   ADVrider > Bikes > GSpot > GS Boxers
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 03-21-2007, 06:28 PM   #14
bemiiten OP
League of Adventures
 
bemiiten's Avatar
 
Joined: Jul 2003
Location: Hamilton NJ.
Oddometer: 4,936
After searching around, this is what I decided on for a gasket sealer. Locktight also sells a similar kit with a primer ,but the primer is for larger clearances and is unnecessary for this application.
I made the decision to install the seals in the cases before hand. The depth of the rear output shaft seal is critical as their is a oil hole that could be covered if its driven in a few mm too far. Installing the seals first means that caution must be taken when heating the cases that the seal is not directly exposed to the blast of the heat gun. I used sockets as a shield. I also covered all the splines with a plastic wrap to protect the seals during assembly. I used gear oil sparingly.
bemiiten is online now   Reply With Quote
 

Share

Thread Tools Search this Thread
Search this Thread:

.
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


Times are GMT -7.   It's 04:35 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2015