ADVrider

Go Back   ADVrider > Bikes > GSpot > GS Boxers
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Search this Thread Display Modes
Old 02-11-2013, 03:33 PM   #1
NH-speed OP
Keepin' the shiny side up
 
Joined: Aug 2008
Location: New Hampshah
Oddometer: 4
Counterbalancer bearing removal

I have a 2005 R12gs with 45k miles. It has a weeping counterbalancer seal that hasn't stopped with a new seal and a new balancer. I did not remove the bearing in the back of the engine, which I plan on doing this month. Question is, has anyone determined how to pull that bearing out without taking the whole engine apart? Any help would be greatly appreciated!
Charlie in NH
NH-speed is offline   Reply With Quote
Old 02-12-2013, 03:47 AM   #2
The Other JC
4 year lurker..
 
The Other JC's Avatar
 
Joined: Apr 2010
Location: Melbourne, Australia
Oddometer: 192
Looking at RepRom, you just need a puller to pull it out after you have taken the gearbox off and removed the seal, after heating the engine block, and removing the shaft. The shaft should pull out after releasing it at the front.
Puller part number 008573 seen here https://www.bmwmc.net/catalog/88%208...0008%20573.pdf

Remove bearing (1) with internal puller (No. 00 8 573) and reaction support (No. 00 8 572) .


There is also a drift for driving the new bearing in .

Drive in new bearing (1) with handle (No. 00 5 500) and drift (No. 31 4 650)

The Other JC screwed with this post 02-12-2013 at 03:52 AM
The Other JC is offline   Reply With Quote
Reply

Share

Thread Tools Search this Thread
Search this Thread:

.
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


Times are GMT -7.   It's 12:31 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014