Drive shaft

kellymac530 · 11-01-2012, 04:46 PM

I am looking at extending a swing arm on an R80G/S and I want to do the method of using 2 drive shafts with one weld rather than a splice with 2 welds.

Are the U-joint ends on all R60 R80 R90 R100 driveshafts the same size?

I have a line on a couple of shafts and don't want to waste my money if the U-joints are different

kellymac530 · 11-01-2012, 04:50 PM

Is it also the same U-joint end on a /2?

11-01-2012, 04:46 PM	#1
kellymac530 ^OP motorcycle addict Joined: Feb 2010 Location: so. cal. Oddometer: 885	Drive shaft I am looking at extending a swing arm on an R80G/S and I want to do the method of using 2 drive shafts with one weld rather than a splice with 2 welds. Are the U-joint ends on all R60 R80 R90 R100 driveshafts the same size? I have a line on a couple of shafts and don't want to waste my money if the U-joints are different __________________ it is easier to ask for forgiveness than permission

11-01-2012, 04:50 PM	#2
kellymac530 ^OP motorcycle addict Joined: Feb 2010 Location: so. cal. Oddometer: 885	Is it also the same U-joint end on a /2? __________________ it is easier to ask for forgiveness than permission

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: .
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode