|
03-12-2013, 10:53 PM
|
#1 |
|
Adventurer
Joined: Apr 2007
Location: Greece
Oddometer: 16
|
Drive saft change on 1150 gs
I am thinking to change it on my own. Is it tricky? Has anyone done it and have some pictures of the work?
__________________
http://giorgos-fantasyfotos.blogspot.com/ GEOF screwed with this post 03-13-2013 at 12:09 AM |
|
|
|
03-13-2013, 04:01 AM
|
#2 |
|
Beastly Adventurer
Joined: Dec 2001
Location: Jax, FL
Oddometer: 10,306
|
It's not hard, but it requires a heat gun, a 30 mm socket, and a 12 mm hex, along with a standard set of hand tools. The final drive has to come off. I've always taken the swingarm off too, but I just read a thread on another board where guys are doing it without removing the swingarm.
Out of curiosity, why are you replacing it?
__________________
Jim Moore "Marines good. Press bad" -Turkish |
|
|
|
|
03-13-2013, 04:25 AM
|
#3 |
|
Just a Wannabe
Joined: Jul 2005
Location: FNQ - AUS
Oddometer: 1,404
|
If you end up separating the two halves of the shaft, be sure to install / re-install with the uni-joints aligned.
There are some threads on here about it and YES it does make a difference, DAMHIK Hay Ewe
__________________
Plan the Day, Fill the Day, be Rewarded by the Day. Moments before you die, your life will flash before your eyes - make sure the film is worth watching - my Grandad  - Preparation + Opportunity = Luck |
|
|
|
 |
| Share |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
