ADVrider

Go Back   ADVrider > Bikes > Thumpers
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Search this Thread Display Modes
Old 03-30-2013, 01:56 PM   #1
ktmdirtybiker OP
Gnarly Adventurer
 
Joined: Sep 2010
Location: western mainline
Oddometer: 158
no valve clearance 530 exc

2010 530 exc 75hours

I have been staying on top of checking the valves every 10 hours till the 50 hour interval. The clearance dropped to the min. by 20 hrs and stayed there up to 50 hrs. At this point I figured it was ok to stretch it out to 25 hrs. At 75 hrs no clearance at all. Yes it is at tdc. Forced out the intake rocker arm by using the bolt in the end of rocker arm and a stack of washers, got shaft out but it will not go back in without force. I am going to guess it is bent slightly and will replace shaft. Any ideas how to get exh side out? Not sure at this point if I should use the same method and kill another rocker shaft or pull the head and use a valve spring compressor. It might be cheaper to kill another shaft ($20) vs buying a ktm valve tool and the gaskets. Any ideas would be helpful.
ktmdirtybiker is offline   Reply With Quote
Reply

Share

Thread Tools Search this Thread
Search this Thread:

.
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


Times are GMT -7.   It's 11:38 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014